Re: how to compile example ftex01

From: Mary Haley (haley AT unknown)
Date: Tue Mar 25 2003 - 15:01:41 MST

Next message: Rolando S. Balotro: "How to Uniinstall"

Previous message: Edward Clutter: "how to compile example ftex01"
In reply to: Edward Clutter: "how to compile example ftex01"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

>
> I am a new user of NCAR and I am working with the examples available under
> ncargex. There is one example I am interested in compiling and running, but
> for some reason when I ran "ncargex -ft3x01" if only generated the ftex01.f
> fortran source file. It did not compile the file or generate the related ncgm
> file. All of the other examples I have been working with did do these steps
> automatically, but this one did not. Could someone tell me what command I
> should use to compile the example "ftex01.f".
> Thanks
> Edward

Hi Edward,

I'm not sure if your command "ncargex -ft3x01" was a typo, or how you
really typed it, but try the following:

ncargex ftex01

You must have version 4.2.x or later of NCAR Graphics in order to run
the Fitgrid examples, which "ftex01" is a part of.

--Mary

> --
> Edward G. Clutter
> Graduate Research Assistant
> School of Aerospace Engineering
> Georgia Institute of Technology
> 270 Ferst Drive
> Atlanta, GA 30332-0150
> gtg401e AT unknown
>
> _______________________________________________
> ncarg-talk mailing list
> ncarg-talk AT unknown
> http://mailman.ucar.edu/mailman/listinfo/ncarg-talk
>

_______________________________________________
ncarg-talk mailing list
ncarg-talk AT unknown
http://mailman.ucar.edu/mailman/listinfo/ncarg-talk

Next message: Rolando S. Balotro: "How to Uniinstall"
Previous message: Edward Clutter: "how to compile example ftex01"
In reply to: Edward Clutter: "how to compile example ftex01"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

This archive was generated by hypermail 2b29 : Tue Mar 25 2003 - 15:03:30 MST